Finally someone who manages to make a decent post when requesting a sound.
Atleast now I know what you are after.
It's a saw waveform (probably 2 saws which are detuned, one to +15, the other to -15) and then the whole thing has some distortion going on.
How to do this?
Use 3XOSC in FL and take 2 saws, set them to the same tuning and set the fine tuning to + and - 15. The third osc should be killed (turn volume to zero). Change the pitich range to 48 (the little box on top that says 1 by default) then turn the main pitchwheel from the 3xOsc (just left of the little box that says 48 now) as far to the left as required to get a saw sound that has the right pitch to immitate the sound from the tune.
To get it distorted you could use the free distortion plugin from Camel audio.
Just put a couple of notes in a pattern and let it loop while you mess with the distortion. A tad of reverb (standard fl reverb, 5% wet, lo-cut 1000Hz, 4ms length) to give it a tad of fullness. And you should be close.
__ Check my soundcloud (exclusive tracks on there)
i believe you, that i have to start with two normal saw waves detuned at +15 and -15 ... but the camelcrusher doesn't bring the desired effect like in the sample above.
any other ideas?
This post has been edited 3 time(s), it was last edited by tequil4: 10-08-2010 22:07.
i just gave it a crack in massive, and drone is pretty much right, you may have to fuck around with a few different filters and distortions as well as some other processing and you should get pretty close. Took me about 5 minutes and I got pretty close, I will have a go at some extra processing and let you know the results.
Originally posted by goonybag
i just gave it a crack in massive, and drone is pretty much right, you may have to fuck around with a few different filters and distortions as well as some other processing and you should get pretty close. Took me about 5 minutes and I got pretty close, I will have a go at some extra processing and let you know the results.
sorry, but what for a crack in massive? haven't found it O_O
otherwise would be a project file very nice to have a look
