drumnbass.be forum » Production » Software » Reason » right way to make bass in Reason right way to make bass in Reason Author Post dnbwhizzkid Tourist Registration Date: 16-06-2007 Posts: 14 im new to this and looking for any advice to help make bass im using reason 3 and at the moment im using the nn-xt sampler and loading in two or three bass samples and de-tuneing them and then adding a scream 4 for a bit of distortion or the other way i was doing it was to combine two or three malstrom synthesizers re wire each one to its own channel on the mixer de-tune them and add a sream 4 for distortion are these ways any good or am i doing it all wrong , if any body could give any advice that would be a great help 23-06-2007 23:26 junkhole Member Registration Date: 02-05-2007 Posts: 62 Helpfulness rating:  that is one way of doing it. load up a combinator and then inside the combinator load a 6:2 mixer. now load up a subtractor... heck load up 6. set them all to square wave and turn on all the ocsillators. detune each synth... example: #1 +14 -14, #2 +9 -9, etc. you can add a couple insert effects if you want. don't pan, keep it all centered. this should give you one crazy big bass sound. i am not on my computer right now so i can look at my presets and give exacts. i think this is what some would refer to as a 'reece' __ Baby Reazin May 21rst 2007- July 25th 2007 24-06-2007 01:14 dnbwhizzkid Tourist Registration Date: 16-06-2007 Posts: 14 fanxs for the advice i tryed doin it that way and i got a much better bass noise 24-06-2007 14:36 junkhole Member Registration Date: 02-05-2007 Posts: 62 Helpfulness rating:  this is a good one too: http://youtube.com/watch?v=y1BI-KVnJuE __ Baby Reazin May 21rst 2007- July 25th 2007 25-06-2007 01:46 drumnbass.be forum » Production » Software » Reason » right way to make bass in Reason